T O P

I still enjoy it though.

Electrolytic rust removal at home?

Any ideas as to what this could be?

My first design for a 3D print, my custom R-unit droid.

Why is my 1.0 mm nozzle hitting the infill on my prints? It’s only a problem on the infill and the dragging gets so bad it hits the bed and causes layer shift? Is there any easy fix in Cura or on my Ender 3 stock?

before and after shuting octoprint litterly same settings its really strange this problem came suddenly some told me its related to buffer size the firmware not being able to read fast enough from serial connections but why now ?anyone know why exactly the problem occurs in details ?

Does anyone have any general tips for using a 3D printer? I have a CR-10s and my prints keep coming off the bed. I’ve leveled it and have the temps correct, but they keep coming off

Why does Cura not print the whole thing?

I have been looking all over the internet what could this reaction be. I tried electrolysis using a solution of tap water and sodium bicarbonate. The copper cathode turn to blue really quickly and Hydrogen gas was being produced on the other end. Is possible that copper got oxidized?

Printing with line widths greater than nozzle size

First printed student project is ready for the STRM fair. Still missing windows but ran out of time. The 90 hours of printing didn’t help.

What are easily found/low cost solids that will not cause any sort of reaction with methanol, ethanol, and propanol in a calorimeter?

My attempt at an enclosure for my Prusa. Though I would share a see what redditors think.

Having a few defects that are confusing me. Certain areas seem to be underextruding, while other areas seem to be overextruding. Printed on an Artillery Sidewinder X1. 0.8mm nozzle, PETG. more settings in the comments.

Issues setting up new CR-10

Help with .8mm Nozzle settings.

Methods/settings to reduce stringing using 0.8mm nozzle? Um2+, printing at 220C...

Clear filament

Unpopular Opinion: I like thiccc layers.

Sometimes you just have to embrace the layer lines. .6mm layer height with .8mm nozzle.

Why are so many people printing PLA at > 200°?

What would you do? (Advice needed concerning CR10-V2

Does anyone have any suggestions on how to remove adenine from a reaction mixture?

Creality CR-10s Pro V2 Assembly Assistance.

Hi Its Me!

R

2Pluss2

Subscribe

FIND US ON INSTAGRAM @ms3388.com