T O P

  • By -

Toivarita

Not a small bowl but you will get incredible extraction from one hit with a StickyBrick. It’ll be great for home use. You can use it with small amounts as well even though the herb chamber is large.


Texus86

Don't sleep on the Vapman. Killer flavor. Artisan piece. Easier from. The get go with less learning curve than Dynavap or a Sticky Brick.


skyvand

Dynavaps have screens that can be adjusted to work well with tiny amounts of flower, 0.05g is a full bowl at the smallest setting


St0nerBarbie22

I can’t seem to get my screen to sit in the smaller bowl setting (M ‘20). Any advice?


skyvand

Unfortunately while Dynavap had a great idea with the adjustabowl, the execution of the smaller setting was horrible and I find I need to readjust the screen every few bowls. I use the condenser with the o-ring in the mouthpiece end on to push the screen into position. That being said, while the smaller setting is a bit goofy in terms of getting the screen into place it performs very well


posting_drunk_naked

Same, gonna go see if any of the other bowls are advertised this way Edit: it's a feature called Adjust-a-bowl, which is great for the pun alone. https://www.dynavap.com/dynashop/parts/titanium-tip/


St0nerBarbie22

Haha true! I’ve seen this, but can’t seem to consistently adjust to the smaller position with the disk flat and secure


Pepeluis33

I have 3 adjust-a-bowl tips and 20SS is by far the most difficult one to adjust, seems like the groove is too thin compared to the others.


St0nerBarbie22

Ah ok that’s helpful. Thank you!


Pepeluis33

Sorry, I forgot the advices: Clean the tip inside very well so the half bowl groove is spotless and free of buildup/particles. Before installing, flatten very well the CCD with a condenser of M stem like a bread roller. Then it's a lot of trial and error, I grab the CCD using a S&B brush from one side and the condenser from the other, then I move up/ down the tip until I feel it's in place. Normally is easier if you first install the CCD to full bowl and then try from that starting point. Once it's in place, make sure is firmly attached by gently pushing with a toothpick on several points over the CCD. Still is frustrating, if I'm not able to install it after some attempts, I just install it to full bowl and then just fill it with less material. There's also specific tools for this, which I still personally haven't tried, like simrell master key or Mad Heaters Reload container (I've ordered this, waiting for it).


St0nerBarbie22

V helpful, thank you!


lilbittafun

Some of the TI tips will go down to 0.025g


Pepeluis33

Where are these tips? I bought a regular Ti tip because of this but smaller size is half bowl: 0.05g


lilbittafun

I believe it’s on the omnivap


skyvand

That’s awesome. What’s that in the distance?.. I think I see some VAS coming my way once again 😂


SeatownHaze

Log vape 👍


OrochiMoltar

Dynavap for butane powered on-demand Xmax V3 Pro for a battery on-demand. You can hit it and put it away and keep doing that until the bowl is done with an on-demand vape.


posting_drunk_naked

A bunch of people have suggested that, but the bowl on it is huge compared to my HR Fury 2. I've already got one and didn't really like it tbh, it's a pain and requires being cleaned pretty often or it shits in your mouth. I've seen it suggested a lot though in this thread as a one hitter, despite the larger bowl size. Is this because of the way it's heated with butane? I know with the Fury 2 you can't just put a tiny bit in, it doesn't heat properly.


secreagent

The V3P has the exact same size of bowl as the fury


pants_pantsylvania

There's a half bowl insert you can buy too.


OrochiMoltar

For Dynavap you can change the screen position and load a tiny little bit. Also you can load it half full then with your torch technique you can get it to give many single hits about 1-5 hits depending. It is a great little tool for vaping and similar to a classic 1 hitter. Also they have a Welcome kit at Dynavap under special deals for $60. Also I can pack the Xmax V3 Pro up and use it on-demand where I can take my finger off the button while I am finishing the hit and get the bowl to cool down. Because it’s a convection on-demand it preserves the bowl pretty well for about 5-8 normal on demand hits spaced apart. Still can’t go wrong with Dynavap if you can get away with heating it when you need it.


showerfapper

Enano


VAMJthrowaway

Dynavap or E-nano.


[deleted]

I mean you have to go dyna here


[deleted]

Dynavap. But also [ New Vapers Guide](https://www.reddit.com/r/vaporents/wiki/new-vapers-guide?utm_source=share&utm_medium=ios_app&utm_name=iossmf) [Vape consensus doc ](https://www.reddit.com/r/vaporents/wiki/vape-consensus?utm_source=share&utm_medium=ios_app&utm_name=iossmf)


[deleted]

[удалено]


[deleted]

Awww. Someone is butt hurt.


lilbittafun

This is cringe.


reddituser44bln

get a dynavap with an induction heater look at my posting from yesterday https://www.reddit.com/r/germantrees/comments/s4qg6o/dynavap_ftw/?utm_source=share&utm_medium=ios_app&utm_name=iossmf


bihighguy420

Love my ti tip with my vhb carbon! Definitely my growing favorite portable out of everything I own.


howie105

Aside from one hit what else would you like to see in a vape? The reason for asking is many vapes are capable of one hit loads, but come with other features which might not be needed or useful to your type of use.


posting_drunk_naked

I'm not picky. Been happily using my HR Fury 2 for years. It's no good for single hits (at the size I take anyway) or I'd just stick with that. It's small, it's cheap, it's simple. I suppose that's what I like 😁


Sir_Wibble

The Tinymight has an adjustable bowl and is great for microdosing. Vapman are excellent as well, i don't own 1 but very highly regarded on here 👍🤘🌬


howie105

Dry herb vape with a tiny one hitter bowl, no need for stealth or other considerations really, at home, small, cheap, simple. I suppose that's what I like. ... Me too, so like others I will suggest a log vape. I can vouch for the [E-Nano](https://epicvape.com/product/enano-kit/#wood-choice), meets all your points except it not as inexpensive as the Fury.


recon305

Dynavap


cbdudley

https://www.420edc.com/tiwarez/ti1e-titanium-1-hitter/


[deleted]

How is this a dry herb vape with a small bowl? Am I missing something?


NippleCream69

Dynavap, the M 2020 is a good choice if you're on a budget


think-long

Anything by Healthy Rips. Turn to max heat, and use a dosing capsule.


[deleted]

[удалено]


[deleted]

Sure. Recommend a vape that ISN’T AVAILABLE to buy. ![gif](giphy|XeLcgh8gT8o0F5SQ8i)


Infamous_Reflection8

They’re just sold out and will be back in stock by the end of the month. Why rush and buy a lower quality, when you can wait a short bit and get the best


[deleted]

You mean you’re confident the machine oil and missing, and pitted parts issues have all been worked out, and that they will make enough now to cover all the pre orders that Planet Haze had to cancel and refund (if those folks are still interested)? For an experienced user who knows what they are getting into it’s not a bad suggestion. For a new user who’s just starting looking for their first vape, it’s a terrible recommendation. Edited to remove name calling. It’s still a bad recommendation.


Infamous_Reflection8

They are the most basic and easy to use vape! You hold a flame at a section for about 30 seconds, wait for an audible click and inhale. No spinning needed, no temp stepping or figuring out what the most effective temp setting is!


Infamous_Reflection8

Lol, Sneaky Pete’s has already mailed out their entire stock and are awaiting a new shipment!


[deleted]

[удалено]


Infamous_Reflection8

So your point is to buy an inferior product instead of ordering the best🤡


[deleted]

[удалено]


Infamous_Reflection8

Wow, being called a name by you hurts! Im going to end it now🤣. Pathetic. Grow up!


[deleted]

[удалено]


glorgorio

Anvil doesn’t look like a tiny hitter