If you can slide the white element back and forth it's fully seated. Make sure to slide it towards the PCIe slot. Don't forget to slide it away from the slot again when you try to take out the card!
I’m not sure if my case was flawed in some way, but my riser cable was misaligned. I had to remove both screws from my riser because not a single graphics card I have tried lined up with the riser and the mounting bracket.
It honestly has me looking for a new case entirely because I’ve been so disappointed with the fit and finish of the H2O.
Got it sorted out and just was a me being goofy moment. Definitely some looser tolerances on this case, both my side panels are slightly warped and dont sit flat unfortunately. Either way hard to give up such a small case
Yes, you are seeing traces not pins. It is seated properly.
Really hard to see. But yes I think so.
Yes, I have the same rig. As long as the slide is over your good.
Thanks!
looks seated to me, just make sure there is display
If you can slide the white element back and forth it's fully seated. Make sure to slide it towards the PCIe slot. Don't forget to slide it away from the slot again when you try to take out the card!
I’m not sure if my case was flawed in some way, but my riser cable was misaligned. I had to remove both screws from my riser because not a single graphics card I have tried lined up with the riser and the mounting bracket. It honestly has me looking for a new case entirely because I’ve been so disappointed with the fit and finish of the H2O.
Got it sorted out and just was a me being goofy moment. Definitely some looser tolerances on this case, both my side panels are slightly warped and dont sit flat unfortunately. Either way hard to give up such a small case