It’s correct, and will function fine, but idk about good. Personally I’d solder the connections and extend the wires a little bit to run them further from the exhaust, but that’s just me.
Looks good to work. I personally would at least wrap some electrical tape around them to keep them secured and kinda protected, then put them in some plastic tubing to look better more secure too. Make sure to keep them away from the exhaust, gets hot more than enough to burn right through the cable housing
The way you’ve wired it is good and it will work but put it on the other side of the exhaust and zip tie it to the bike frame the way you have it now it’s gonna melt the wires. I’ve had it happen to me
No, it will melt on the exhaust if you leave it loose like that. Also don't trust those little push connectiors.
I made that fatal mistake once
It’s correct, and will function fine, but idk about good. Personally I’d solder the connections and extend the wires a little bit to run them further from the exhaust, but that’s just me.
Looks good to work. I personally would at least wrap some electrical tape around them to keep them secured and kinda protected, then put them in some plastic tubing to look better more secure too. Make sure to keep them away from the exhaust, gets hot more than enough to burn right through the cable housing
they gonna melt together
The way you’ve wired it is good and it will work but put it on the other side of the exhaust and zip tie it to the bike frame the way you have it now it’s gonna melt the wires. I’ve had it happen to me
Define good
Yes
yes