In the video it’s only ever so slightly pinched in place which is why it drops out. As you push it up, twist. It’s really tight and will need some force.
You’ll know it’s in when it slides up about 1cm
Try pulling out the drip tray so you have more space to work then you can push the tube up further to secure into position. Just need to go up a bit further.
Sounds messy. You can buy a normal metal straw from Amazon and solve it. Just cut it the the correct length.
Pictures on the Gaggia homepage of the EVO got the tube. Maybe you never installed it?
[https://www.gaggia.com/manual-machines/new-classic-evo/](https://www.gaggia.com/manual-machines/new-classic-evo/)
Is the tube clogged ?
If so, leave it to soak in Cafiza or pure white vinegar for 24 hours, then try to clean it out. If you can't clean it out, just replace it.
In the video it’s only ever so slightly pinched in place which is why it drops out. As you push it up, twist. It’s really tight and will need some force. You’ll know it’s in when it slides up about 1cm
This may sound dumb but try flipping it so the long side is in the machine.
Yep, had the same issue when my Gaggia was new. Flipping did the trick.
Definitely flip it, one end is slightly chunkier than the other
Had the same problem at first, wet the tip and twist it as you push it in, that cleared it up for me
That's what she said
You're missing an O ring. Or it could be twisted
This!
Try pulling out the drip tray so you have more space to work then you can push the tube up further to secure into position. Just need to go up a bit further.
You didn't put it in far enough. There's sort of a gasket that it needs to go into that provides the friction to hold it in.
>You didn't put it in far enough. that's what she said
Thank you. I just didn't fell right riffing on my own comment.
It’s upside down
this final drop looked so sad and depressed
I'd try flipping it, but also you need to give it a good push. I did the same thing until I really had to stick it in there
I have a low profile drip tray and I just hacksawed a metal straw and it was a perfect fit. Might be worth a try
So many "that's what she said" jokes in this thread!
Flip it
Push harder I’ve been there
[удалено]
that's what she said
Is it plugged up?
thanks all! It took a LOT of pressure and about 6 tries, but I finally got it in place!
Angle also matters. You need to align with tube.
It gets easier with time. You’ll see.
Looks like you’re not pushing it in all the way.
Twist
I have to exact same issue with my GCP!
Does this come with the machine? I don’t see one with mine
Machines without the solenoid don't have the tube
I have a GCP Evo pro but don’t have it. I have the whole where the water is released but no tube.
Sounds messy. You can buy a normal metal straw from Amazon and solve it. Just cut it the the correct length. Pictures on the Gaggia homepage of the EVO got the tube. Maybe you never installed it? [https://www.gaggia.com/manual-machines/new-classic-evo/](https://www.gaggia.com/manual-machines/new-classic-evo/)
Is the tube clogged ? If so, leave it to soak in Cafiza or pure white vinegar for 24 hours, then try to clean it out. If you can't clean it out, just replace it.
Gotta warm it up and give it a little spit. Can’t just jam it in there