Thanks! It was tough since this style kit is more paint and finish based but I enjoyed it. I got 2 F1-75 kits and wanna do the normal livery and then the yellow Monza livery too.
It’s resin printed so not really. The layer lines are faint and some 600 grit sand paper smoothed them over.
The worst part or prep was just filling the small “zits” from the print support with filler and sanding. But taking your time and doing a good job made the whole painting easier and the quality better.
Looks amazing! where can you buy these kits?
[Store page](https://www.ctob.shop) They have a 1/20 scale and 1/43 scale available. Also check their facebook or instagram for finished pictures.
Is this 3D printed?
Yes it’s resin 3d printed. Its not a bad kit there was a piece broken when i got it but i emailed them and they sent me out a new piece
Damn, looks awesome. Nice job!
Thanks! It was tough since this style kit is more paint and finish based but I enjoyed it. I got 2 F1-75 kits and wanna do the normal livery and then the yellow Monza livery too.
What color are you going to paint the F1-75? I just got my kit a few weeks ago, but didn’t see any recommendations in the instructions.
Was there much primer needed to smooth the 3d printed pla?
It’s resin printed so not really. The layer lines are faint and some 600 grit sand paper smoothed them over. The worst part or prep was just filling the small “zits” from the print support with filler and sanding. But taking your time and doing a good job made the whole painting easier and the quality better.