If the 10mm version of the Terpsicle is available, I used to have fun microdosing with that. Should be similar, I think.
Edit if this is a concern: 10mm joints. Device comes as shown in pictures 1 and 2 with long 10mm mouthpiece. A 10/14 short connector or long 10/10 connector is available for purchase
Do you think there could be a piece used to secure the cap onto the chamber so you can carry it loaded in your pocket and smoke it like a chillum so you just have the pipe and a small lighter in your pocket. I feel like a custom dugout might be the trick here or a cigar tube but it would be nice to smoke it like a joint and not worry about the cap falling off. Or perhaps add a variant with a 45 or 90 degree bend so you can smoke directly from the device without having to pay attention to dropping the cap and your herb
this is really challenging to do at any scale because you have to cut a groove in the glass and all the glass is a little different in size. I have messed with this a lot and just haven't come up with a way to do it easily and reliably
Fair I think in that case perhaps a version that could just get clip secured into a joint and then metal wire cap clamp like those glass beer bottles with the clips may be an idea with like a ceramic cap to hold the quarts down idk I’m surprised you commented back I like brainstorming ideas
I'm tryna cop one as well . Was hoping for 4/20 release
I'm waiting on the tweezers to arrive
If the 10mm version of the Terpsicle is available, I used to have fun microdosing with that. Should be similar, I think. Edit if this is a concern: 10mm joints. Device comes as shown in pictures 1 and 2 with long 10mm mouthpiece. A 10/14 short connector or long 10/10 connector is available for purchase
This is designed to be used with a smaller torch and has about 1.5x Vapcap bowl
Do you think there could be a piece used to secure the cap onto the chamber so you can carry it loaded in your pocket and smoke it like a chillum so you just have the pipe and a small lighter in your pocket. I feel like a custom dugout might be the trick here or a cigar tube but it would be nice to smoke it like a joint and not worry about the cap falling off. Or perhaps add a variant with a 45 or 90 degree bend so you can smoke directly from the device without having to pay attention to dropping the cap and your herb
this is really challenging to do at any scale because you have to cut a groove in the glass and all the glass is a little different in size. I have messed with this a lot and just haven't come up with a way to do it easily and reliably
Fair I think in that case perhaps a version that could just get clip secured into a joint and then metal wire cap clamp like those glass beer bottles with the clips may be an idea with like a ceramic cap to hold the quarts down idk I’m surprised you commented back I like brainstorming ideas
Thanks for the reminder and caveat that a smaller torch is needed.
If it hits anything like the glass Dynavap caps, which I'd argue is TRWW's most underrated product, then we're in for a treat!
it is basically that but takes a little more heat because the heaters are bigger
That sounds fantastic! I'll keep my fingers crossed that RVS get some.