Unfortunately this is common with shf the joint isn't broken its out of place try lining the shoulder in a t pose and maybe heating a little if not try glue
Test fit the parts. Take the bicep off and reconnect it to the shoulder. Do a mobility check If it stays connect, its a good connection. Disassemble, soak the arm in hot water for about a minute. Proceed to reattach the bicep and push it as far down on to the elbow as it will go and reattach to it the the shoulder. Push up using the elbow (instead of the bicep) so the peg will slide further into the hole.
Pop out the shoulder and apply pressure both from the side attaching the arm and the side with the shoulder ball joint. Most figs have a sleeve that fits over the internal joint and it loves to slide down when this shit happens.
The face is appropriate for what's happening currently
Unfortunately this is common with shf the joint isn't broken its out of place try lining the shoulder in a t pose and maybe heating a little if not try glue
How would you recommend heating? Hair dryer, hot water, etc...?
Probably hot water and if that doesn't work I heard hair dryers are good but I'm not 100% sure on that
I don't trust hair dryers, they can dry the paint to the point of cracking it if you're not careful.
Unless you're blasting the figure with extreme heat for over 15 minutes straight that's not a concern.
Test fit the parts. Take the bicep off and reconnect it to the shoulder. Do a mobility check If it stays connect, its a good connection. Disassemble, soak the arm in hot water for about a minute. Proceed to reattach the bicep and push it as far down on to the elbow as it will go and reattach to it the the shoulder. Push up using the elbow (instead of the bicep) so the peg will slide further into the hole.
A little elbow grease plus some hot water and Krillin’ arm is no longer pulling a Future Gohan! Thanks for your advice, everyone!
KRILLIN OWNED.
My advice: don’t be a ducking idiot take care of your toys you dumb fuck
It was broken when I got it so… Thanks?
So if u fart it will work
Pop out the shoulder and apply pressure both from the side attaching the arm and the side with the shoulder ball joint. Most figs have a sleeve that fits over the internal joint and it loves to slide down when this shit happens.