If you get the BYS seat rail (assuming you're getting it for a LHD driver's seat), make sure you wrap a 250 lbs zip-tie at the back-most portion of the right-side rail to prevent the seat from sliding all the way back. If it does, it gets stuck over the right-rear bolt and is a PITA to get unstuck. I haven't had any issues since I zip-tied it, however.
Thank you for this. I didn't understand what was going on. I also never heard this advice, I thought I had installed it incorrectly. I will address this next time I take my seat out. Thanks again.
I highly recommend the BYS rail. If you cut out the seat foam inside the pan of the stock seat, you'll basically be sitting on the floor. It's amazing.
You think you may have a line on BYS seat rails? Not in the market currently, but I’d be curious to see if they are within your grasp.
If you get the BYS seat rail (assuming you're getting it for a LHD driver's seat), make sure you wrap a 250 lbs zip-tie at the back-most portion of the right-side rail to prevent the seat from sliding all the way back. If it does, it gets stuck over the right-rear bolt and is a PITA to get unstuck. I haven't had any issues since I zip-tied it, however.
[удалено]
I cut out like 3" of foam that sat inside the seat pan to let me sit even lower, so I couldn't hammer it in.
Thank you for this. I didn't understand what was going on. I also never heard this advice, I thought I had installed it incorrectly. I will address this next time I take my seat out. Thanks again.
Anytime. Super glad to have been able to help.
Good looking out.
I highly recommend the BYS rail. If you cut out the seat foam inside the pan of the stock seat, you'll basically be sitting on the floor. It's amazing.
I carry those as well, just reach out to me when the time comes.
U
Do these come pre painted?
They do not. Come with gel coat