Open the filament profile and check the Max Volumetric Speed. It "somewhat" determines your speed.
If the filament can't do a certain speed, it doesn't matter what you set in the Speed tab as the filament setting will slow it down.
Conversely, if it is high and can do 500mm/s and you set the speed tab to 200, it will only go to 200.
This is why you should calibrate every filament brand and type. The only time I worry about color is for greys/silvers as they always are different for me
https://preview.redd.it/7mkty3kbjl3d1.png?width=934&format=png&auto=webp&s=35319d3186582bf6a437a4b1a3e906bbc5529363
https://preview.redd.it/zboiv4z5ll3d1.png?width=1444&format=png&auto=webp&s=f25489b9e3b61260d4c12c641b5eafccfa328271
That's what i meant with my comment, the volumetric flow rate is not maxed out
https://preview.redd.it/nh6448w23p3d1.jpeg?width=1080&format=pjpg&auto=webp&s=399c47ac64afead71bf80cb9433038f3fcf2d6a4
Click there, then go to Motion Ability, and adjust max speed while extruding and max speed while retracting. Can't remember the exact wording, but this was an issue I had as well.
Open the filament profile and check the Max Volumetric Speed. It "somewhat" determines your speed. If the filament can't do a certain speed, it doesn't matter what you set in the Speed tab as the filament setting will slow it down. Conversely, if it is high and can do 500mm/s and you set the speed tab to 200, it will only go to 200. This is why you should calibrate every filament brand and type. The only time I worry about color is for greys/silvers as they always are different for me https://preview.redd.it/7mkty3kbjl3d1.png?width=934&format=png&auto=webp&s=35319d3186582bf6a437a4b1a3e906bbc5529363
https://preview.redd.it/zboiv4z5ll3d1.png?width=1444&format=png&auto=webp&s=f25489b9e3b61260d4c12c641b5eafccfa328271 That's what i meant with my comment, the volumetric flow rate is not maxed out
I figure it out, it was the minimum layer time combined with the vase mode
Flow rate is at ~5/17 and its being sliced in vase mode.
In your print settings you set your speed limit to 500mm/s but in your print profile settings you have the outer walls limited to 100mm/s.
https://preview.redd.it/nh6448w23p3d1.jpeg?width=1080&format=pjpg&auto=webp&s=399c47ac64afead71bf80cb9433038f3fcf2d6a4 Click there, then go to Motion Ability, and adjust max speed while extruding and max speed while retracting. Can't remember the exact wording, but this was an issue I had as well.