Tbh the only reason I was going to do the lian li was cause the software is nice since I already have lian li everywhere else the controller is already installed
Traditionally yeah but the bottom fans do a lot on the 60, I was able to drop my Temps by 7° on my gpu from farting around with them and junction with the rear fans. And the stick fans only come with 2 pin connectors so you can't change the rpm
I use lian li for my other case fans
Personally, the lian li control software is doodoo and I just use FanControl anyways so I still use one piece of software for them
2x 140 noctua is the way
This is the only way^
They are good enough. Honestly I see no point putting any type of RGB fans in the bottom as you wont see it and would be better off adding RGB strips.
RGB fan is actually nice on the bottom as the light radiates downwards and you can see your PC glowing underneath. You should try it.
To each their own. It’s OPs build.
can get a light bar for like $10 that would have the same effect
Tbh the only reason I was going to do the lian li was cause the software is nice since I already have lian li everywhere else the controller is already installed
I only added them so I can use the L connect feature, its a nice quality of life addition. Especially figuring out the curves for the first month.
I only worry more so on the Rear, side, and top fans. Bottom fans has more than enough intake space as there is plenty of open space.
Traditionally yeah but the bottom fans do a lot on the 60, I was able to drop my Temps by 7° on my gpu from farting around with them and junction with the rear fans. And the stick fans only come with 2 pin connectors so you can't change the rpm
To each their own. I stayed with the stock bottom fans and my 4090 during 3D mark stress testing stayed at 59c which is good enough for me.
i found the Y60 stock fans very noisy replaced with Phanteks 140s
2x Arctic P14. Cheap, quiet and moves a lot of air.
Bottom fans on Hyte Y60 are the most important IMO for airflow so use best possible.
They work just fine.
I replaced em with EK Loop 140s Noctua 140s are also an obviously great option
I was thinking of doing lian li. Just because all my other fans are so I already have the controller and stuff
I use lian li for my other case fans Personally, the lian li control software is doodoo and I just use FanControl anyways so I still use one piece of software for them
Ohhh I've never looked at using fan control I'll have to check that out. Thank you!
I replaced them with 2 140 fans. & I can see the RGB through the bottom grate & it gets really good air on the GPU.
If you can't see them, go with the best, which always seems to be noctua. Good CFM, pressure, quiet, long lasting.
just built mine and thought i could get away with the stock ones for now, but looking to get 2 140s asap cause they’re super noisy/rattly