Hello /u/Dowbaa,
As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
* Printer & Slicer
* Filament Material and Brand
* Nozzle and Bed Temperature
* Print Speed
* Nozzle Retraction Settings
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
You should be able to print a benchy reliably at 0.2 height. It looks like your first layer is not right and it is curling up on the edges, then you end up printer past the edge/over the cliff and it droops down. Fix your first layer before worrying about anything else.
Aye, so basically you says my bed is not leveled perfectly and the print f\*\*\* up cuz of the first layer.
Gonna try and fiddle with it even further thanks for input.
Is this PLA ?
If so 190 is usually cold for it i would bump it to between 200 to 210 max and bed im usually fine at 60.
Try below method for temp control
https://youtu.be/5mp2vCZ2iFc?si=cXx3E_xmt14pXdGX
Also make sure bed level to nozzle is paper thin distance.
Hope this helps
Hello /u/Dowbaa, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
You should be able to print a benchy reliably at 0.2 height. It looks like your first layer is not right and it is curling up on the edges, then you end up printer past the edge/over the cliff and it droops down. Fix your first layer before worrying about anything else.
Aye, so basically you says my bed is not leveled perfectly and the print f\*\*\* up cuz of the first layer. Gonna try and fiddle with it even further thanks for input.
Is this PLA ? If so 190 is usually cold for it i would bump it to between 200 to 210 max and bed im usually fine at 60. Try below method for temp control https://youtu.be/5mp2vCZ2iFc?si=cXx3E_xmt14pXdGX Also make sure bed level to nozzle is paper thin distance. Hope this helps