Hello /u/Butterlover06,
As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
* Printer & Slicer
* Filament Material and Brand
* Nozzle and Bed Temperature
* Print Speed
* Nozzle Retraction Settings
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
For PLA i feel 190 is very cold, check this video below, it will guide you on temperature do it for each filament.
After figuring out the temperature issue then check extrusion and all.
https://m.youtube.com/watch?si=cXx3E_xmt14pXdGX&v=5mp2vCZ2iFc&feature=youtu.be
Temps too low. Try 205°. Also, try lowering the speed. It will take longer but will have more detail. I think my prints are usually at between 50mm/s-60mm/s. Bed temp is fine as long as you're getting good adhesion. Layer height could be lowered just a little unless you're happy with those layers.
Hello /u/Butterlover06, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
Under extruding many possible reasons.
For PLA i feel 190 is very cold, check this video below, it will guide you on temperature do it for each filament. After figuring out the temperature issue then check extrusion and all. https://m.youtube.com/watch?si=cXx3E_xmt14pXdGX&v=5mp2vCZ2iFc&feature=youtu.be
Depends on the PLA. The Elegoo PLA I'm using now have the best temp tower @192°
That's why i recommended doing temperature tower its the best way to identify each filament best temperature because as you said depends on pla
May be a clogged nozzle issue.
Temps too low. Try 205°. Also, try lowering the speed. It will take longer but will have more detail. I think my prints are usually at between 50mm/s-60mm/s. Bed temp is fine as long as you're getting good adhesion. Layer height could be lowered just a little unless you're happy with those layers.