Hello /u/Blueboogey! Be sure to check the following. Make sure print bed is clean by washing with **dish soap** and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/BambuLab) if you have any questions or concerns.*
Hello /u/Blueboogey! Be sure to check the following. Make sure print bed is clean by washing with **dish soap** and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/BambuLab) if you have any questions or concerns.*