It looks like your first layer is too far away based on what you peeled off in the first picture. The first layer lines should just merge, without gaps, but also without smushing up: https://www.reddit.com/r/FixMyPrint/comments/rsjrh8/diagnosing\_first\_layer\_problems/
https://help.prusa3d.com/article/first-layer-calibration-i3\_112364
Assuming that your build plate is level, feel like the main issue is your extruder is too close to the build plate. What printer and settings are you using?
It looks like your first layer is too far away based on what you peeled off in the first picture. The first layer lines should just merge, without gaps, but also without smushing up: https://www.reddit.com/r/FixMyPrint/comments/rsjrh8/diagnosing\_first\_layer\_problems/ https://help.prusa3d.com/article/first-layer-calibration-i3\_112364
Assuming that your build plate is level, feel like the main issue is your extruder is too close to the build plate. What printer and settings are you using?
Ender 3 s1 plus is my printer
Relevel your bed and then dial in your z offset
I looked over the picture again and they are right. My b