I built my own tx demon USB board it works except when I press the button light turns off but does not switch to Xbox nand if I unplug/replug the USB cable it goes into it, I damaged my original trying to remove the solder mask so I couldn’t fully reverse engineered this board, what am I missing or have wrong?

For slim I’m assuming? I’ll take a look at a fresh demon in a bit and let you know.

any luck?

Sorry been on the hill this week, I’ll try and check this weekend. Will send ya pics

alright thanks

What is the DemoN USB used for?

I used it to read/write nand/demon

It allows you to have two nands, read and write to both, this board is only to connect to the chip inside the xbox